Single girder suspension cranes

The optimal solution up to 10,000 kg load capacity for small or low production halls.


Space-saver in small or low halls

The single girder suspension crane requires very little space and runs on the bottom flange of the crane runway, which is mounted on roof beams or directly on the ceiling. The complete width of the hall is thus available. The distance between the load hook and side walls is extremely small in this case. With this type of crane it is possible to connect various suspension cranes with the help of a crane interlock to enable them to pass hoists with or without loads. In this way it is possible to reach any and every point in a combined system. Passing on a spur runway is also possible.

Competent local partners, many of whom are certified, plan, produce and install single girder suspension cranes with high-quality technology from STAHL CraneSystems. You can find the right contact on our contacts page.

  • Minimal approach dimensions and low headroom for optimal utilisation of small, low halls
  • Crane interlock for transporting material over different aisles
  • Explosion-proof versions or off-standard solutions through engineering
  • Worldwide network of certified partners, crane manufacturers and system builders

A single-girder suspension crane with four beams transports machine parts and prototypes.


All cranes are equipped with frequency-controlled drives in order to be able to move the sensitive engine parts very slowly and as pendulum-free as possible.


In a maintenance hangar in Kenya, single-girder suspension cranes with special suspensions are used.